KTC KTC16B, Owner'S Manual, Page: 8 / 88

10
Owner’s Manual
Use recommended speed for drill accessory and workpiece material.
Be sure drill bit or cutting tool is securely locked in the chuck
Adjust the table or depth stop to avoid drilling into the table
Shut off the power, remove the drill bit, and clean the table before leaving machine.
Do not connect tool to power source or operate until it is completely assembled and installed
according to the instructions
If any part of your drill press malfunctions or has been damaged or broken, do not operate until the part
is properly repaired or replaced.
Never place your fingers in a position where they could contact the drill
Or other cutting tool if the workpiece should unexpectedly shift.
Never perform any operation
By moving the head or table with respect to one another. Do not turn the motor switch ON or start any
operation before checking that the head and table support lock handle is clamped tight to column and
head and table support collars are correctly positioned.
Before engaging the power switch on, make sure the belt guard is down and the chuck is
installed properly.
Lock the motor switch off when leaving the drill press
Do not perform layout, assembly, or setup work on the table while the cutting tool is rotating, switched
on or connected to a power source.
If the power supply cord is damaged
It must be replaced only by the manufacturer or by an authorized service center to avoid risk.
Save these instructions
Refer to them frequently and use to instruct other users. If you loan someone this tool, loan them these
instructions also.
Health warning
WARNING
This product and some dust created by power sanding, sawing, grinding, drilling, and
other construction activities may contain chemicals, including lead, known to cause
cancer, birth defects, or other reproductive harm. Wash your hands after handling.