KTC KTC16B, Owner'S Manual, Page: 23 / 88

Owner’s Manual
25
1. Remove protective bag from head assembly and discard. carefully lift head above column tube and
slide onto the column making sure head slides down over column as far as possible. Align head with
table and base.
2. Using a 5 mm hex key, install a set screw in each hole as indicated on the right side of the head.
Tighten the two head lock set screws.
Tensioning the belts
See Figure 10.
1. Apply tension to belt by turning belt tension handle counterclockwise until belt deflects approximately
1/2 in. by thumb pressure at its center.
2. Tighten belt tension lock handles.
Note
Over tensioning belt may cause motor not to start or damage bearings.
3. If belt slips while drilling, readjust belt tension.
A - Head assembly
B - Set screw