KTC KTC16B, Owner'S Manual, Page: 33 / 88

Owner’s Manual
35
Drilling to a specific depth
See Figure 19.
To drill a blind hole (not all the way through) to a given depth, proceed as follows.
1. Mark the depth of the hole on the workpiece.
2. Loosen the depth scale lock.
3. With the switch OFF (O), bring the drill bit down until the tip of lip of the bit are even with the mark.
4. Turn the depth scale counterclockwise until it stops moving.
5. Tighten the depth scale lock.
6. The drill bit will stop at this depth until the depth scale is readjusted.