EN
page 35
If needed, the
"R"
cycle can be activated even during the wash-tank loading. If the activation
happens during the wash-cycle, this will be elongated.
The circuit board is designed to call periodically for a 20 min. manual regeneration cycle.
This regeneration cycle can also be activated by the user, should the rinse quality be
dissatisfactory.
When the display shows
“PRESS WATER SOFTNER REGENERATION KEY"
or when the users want to activate the
“R”
regeneration cycle, start the following
procedure:
• Should the display show
"SALT LEVEL"
, fi ll the special container, placed on the inside
of the tank, with coarse salt (1-4 mm. grains), being careful not to spill it into the sump. A
strong concentration of salt can negatively affect the correct functioning and service life of
the machine and generate rust and the steel oxidation. After fi lling with salt, lock the plug
tightly.
• With the machine in
"STAND-BY"
mode, the water valve open, the wash-tank empty
and the door shut, press the
"D"
button. The button
"A"
will start fl ashing in blue.
• During this cycle, the display will show the steps in progress and the time remaining.
• This cycle cannot be interrupted and the normal operation is inhibited.
• At the cycle end, the machine will switch in
"STAND-BY"
mode, automatically.
At this moment, it is possible to switch the machine OFF (see par. 2.2.3 Switching OFF) or
start a normal operation phase(see 2.2.2 Operation).
In case of water hardness above 35°f an external water softener is recommended.
R
press water softner
regeneration key
SALt
%%%%%
SOFTNER REGENER
STAND-BY
