FusionClient – User Guide (Rev. 1.3)
www.kontron.com
// 45
4.7.
Rear Side
Figure 22: Rear side of the FusionClient shown as FC 215
1
Rear side of the touch display unit
2
Cover of the computer base with cooling fins
3
Screws that secures the cover with cooling
fins to the display unit
4
Gasket location (around the rear side of the
touch display unit)
5
Interface side of the computer base
6
14 x mounting clamps with screws
7
4x M4 threaded blind holes (8mm max) for
mounting of the optional VESA® 75/100
compliant mounting adapter
8
Type label
When powering on the FusionClient, make sure that the air intake and exhaust
openings are not obstructed and the cooling fins not covered by objects.
Please do not remove the screws marked with red in the picture (Figure 22 pos. 8).
Refer to the note for mounting clamps in section 4.5 “Left and Right Side View”.
Please observe the warning label “Hot Surface” shown in Figure 22 on the rear side
of the system. The chassis may be hot during operation and should not be touched
without taking care.
The material on bottom surface of the enclosure interior where the FusionClient is
to be mounted, shall keep at least flammability class UL 94-5VB. Don’t put
1
5
3
3
2
6
6
6
6
4
6
6
6
6
6
6
6
6
6
6
7
8
Summary of Contents for FusionClient FC 121
