FusionClient – User Guide (Rev. 1.3)
www.kontron.com
// 41
4.4.12.
X 12 – Optional serial Port COM3 (RS422/RS485)
The interface (X 12, Figure 12, pos. 14), if ordered can be provided on your FusionClient as an RS422 or
RS485 serial port, 9-pin D-SUB connector (female). This port can be configured corresponding to your
requirements at factory only. For RS422 pin assignment, refer to subsection 9.2.2 and for RS485 refer to
9.2.3 and 9.2.4.
The customized settings for RS485 mode communication allow the system’s operation either in full
duplex mode or in half duplex mode.
4.4.13.
X13 - Optional Extension Port (D-Sub Type Connector)
Figure 17: Extension Port for optional interface
If ordered, this D-Sub type extension port (X13, Figure 12, pos. 15) can be configured corresponding to your
requirements at factory only.
4.4.14.
Mounting Slots on the bottom Side of the Touch Display Unit 9.2.1
On the bottom side of the touch display unit are available two pairs of mounting slots (Figure 12, pos. 5
and Figure 18, pos. 1) for the installation of the provided mounting clamps with screws (Figure 18, pos. 2).
Figure 18: Bottom side of the touch display unit with installed mounting clamps (enlarged)
1
Pairs of mounting slots
2
Mounting clamp with screw
Note for mounting clamps:
The FC 215 and FC 185 system will be secured into a wall/panel by use of:
four mounting clamps at the top and bottom side
three mounting clamps at the left and right side
The FC 156 system will be secured into a wall/panel by use of:
four mounting clamps at the top and bottom side
two mounting clamps at the left and right side
The optional interface on the bottom side of the FusionClient must
be ordered separately. To add an optional interface to the system,
the second mPCIe socket of the baseboard), will be used. This
connection can be implemented at factory only.
2
1
1
2
Summary of Contents for FusionClient FC 121
