FusionClient – User Guide (Rev. 1.3)
www.kontron.com
// 55
2.
Ensure that the DC power source is switched off via a disconnecting device (circuit breaker), in order
to ensure that no power is flowing from the external DC power source during the connection
procedure.
3.
Connect at first the wire for the grounding stud” (Figure 12, pos. 11) to an appropriate “common earth”
connection point.
4.
Connect the Phoenix power terminal prepared as described in subsection 6.1.1 ”Cabling” to the DC
input connector (Figure 12, pos. 1, marked X1) of the FusionClient. The DC input connector is located on
the front side and is marked “24 VDC”.
5.
Connect the other ends of the DC power wires to the connections of the DC main power supply. Pay
attention to the polarity of the connections.
6.
Switch on the disconnecting device (circuit breaker) in order to apply voltage to the terminals of the
power wires.
Summary of Contents for FusionClient FC 121
