FusionClient – User Guide (Rev. 1.3)
For Your Safety
Your new Kontron product was developed and tested carefully to provide all features necessary to ensure
its compliance with electrical safety requirements. It was also designed for a long fault-free life.
However, the life expectancy of your product can be drastically reduced by improper treatment during
unpacking and installation. Therefore, in the interest of your own safety and of the correct operation of
your new Kontron product, you are requested to conform with the following guidelines.
High Voltage Safety Instructions
As a precaution and in case of danger, the power connector must be easily accessible. The power
connector is the product’s main disconnect device.
Warning
All operations on this product must be carried out by sufficiently skilled personnel
only.
Electric Shock!
Before installing a non hot-swappable Kontron product into a system always
ensure that your mains power is switched off. This also applies to the installation
of piggybacks. Serious electrical shock hazards can exist during all installation,
repair, and maintenance operations on this product. Therefore, always unplug the
power cable and any other cables which provide external voltages before
performing any work on this product.
Earth ground connection to vehicle’s chassis or a central grounding point shall
remain connected. The earth ground cable shall be the last cable to be
disconnected or the first cable to be connected when performing installation or
removal procedures on this product.
Special Handling and Unpacking Instruction
ESD Sensitive Device!
Electronic boards and their components are sensitive to static electricity.
Therefore, care must be taken during all handling operations and inspections of
this product, in order to ensure product integrity at all times.
Do not handle this product out of its protective enclosure while it is not used for operational purposes
unless it is otherwise protected.
Whenever possible, unpack or pack this product only at EOS/ESD safe work stations. Where a safe work
station is not guaranteed, it is important for the user to be electrically discharged before touching the
product with his/her hands or tools. This is most easily done by touching a metal part of your system
housing.
It is particularly important to observe standard anti-static precautions when changing piggybacks, ROM
devices, jumper settings etc. If the product contains batteries for RTC or memory backup, ensure that the
Summary of Contents for FusionClient FC 121
