FusionClient – User Guide (Rev. 1.3)
www.kontron.com
// 15
1/
General Safety Instructions for IT Equipment
Please read this chapter carefully and take careful note of the instructions, which
have been compiled for your safety and to ensure to apply in accordance with
intended regulations. If the following general safety instructions are not observed,
it could lead to injuries to the operator and/or damage of the product; in cases of
nonobservance of the instructions Kontron is exempt from accident liability, this
also applies during the warranty period.
The product has been built and tested according to the basic safety requirements for low voltage (LVD)
applications and has left the manufacturer in safety-related, flawless condition. To maintain this
condition and also to ensure safe operation, the operator must not only observe the correct operating
conditions for the product but also the following general safety instructions:
The product must be used as specified in the product documentation, in which the instructions for
safety for the product and for the operator are described. These contain guidelines for setting up,
installation and assembly, maintenance, transport or storage.
The on-site electrical installation must meet the requirements of the country's specific local
regulations.
If a power cable comes with the product, only this cable should be used. Do not use an extension
cable to connect the product.
To guarantee that sufficient air circulation is available to cool the product, please ensure that the
ventilation openings are not covered or blocked. If an air filter is provided, this should be cleaned
regularly. Do not place the system close to heat sources or damp places. Make sure the system is well
ventilated.
Only devices or parts which fulfill the requirements of SELV circuits (Safety Extra Low Voltage) as
stipulated by
IEC 60950-1 may be connected to the available interfaces.
Before opening the device, make sure that the device is disconnected from the mains.
Switching off the device by its power button does not disconnect it from the mains. Complete
disconnection is only possible if the power cable is removed from the wall plug or from the device.
Ensure that there is free and easy access to enable disconnection.
The device may only be opened for the insertion or removal of add-on cards (depending on the
configuration of the system). This may only be carried out by qualified operators.
If extensions are being carried out, the following must be observed:
•
All effective legal regulations and all technical data are adhered to.
•
The power consumption of any add-on card does not exceed the specified limitations.
•
The current consumption of the system does not exceed the value stated on the product label.
Only original accessories that have been approved by Kontron can be used.
Please note: safe operation is no longer possible when any of the following applies:
•
The device has visible damages.
•
The device is no longer functioning.
In this case the device must be switched off and it must be ensured that the device can no longer be
operated.
Summary of Contents for FusionClient FC 121
