Konica Minolta PCL-400, User Manual

Page: 64 / 357

3-5
3.2 Checking the setup
This section provides an overview of the setup procedure that is required for each net-
work printing method.
Peer-to-peer printing
1
Connect the network cable. (Refer to “Connecting to a local area network
(LAN)” on page 1-12.)
2
From the machine’s control panel, specify the IP address, subnet mask and de-
fault gateway. (Refer to “Specifying an IP address” on page 3-9.)
3
Print the settings information, and then check the settings. (Refer to “Printing
the settings information” on page 3-13.)
4
Install the printer driver. The Peer-to-Peer Utility is installed when the printer
driver is installed.
– For details on installing the PCL driver, refer to “Installing the printer driv-
er by using the AutoRun Installation” on page 2-15.
– If the GDI driver is to be installed, refer to the User’s Guide for the GDI
printer controller, included with this machine.
5
Add the network port to the computer. (Refer to “Connecting the computer and
this machine over a network” on page 3-15.)
2
Reminder
When installing the printer driver on an operating system other than Windows
Me, the Peer-to-Peer Utility is not installed.