10
Chapter 1—First Time Setup and Configuration
2.
In Internet Protocol (TCP/IP) Properties dialog box, select
Use the following IP
Address.
3.
In their corresponding boxes, type the new
IP address
,
Subnet mask
and
Default
gateway
(if applicable).
4. Click
OK.
5.
In the Local Area Connection Properties dialog box, click
OK
.
Configuring the IPv6 Address
1.
In the
IPv6 Address
area, verify the address is correct. If it is correct, proceed to
Configuring the AppleTalk Zone
. If the settings are not correct, select the
Support
IPv6
check box to enable IPv6 addressing.
The following message appears:
“You need to restart the application for the new settings to take effect”.
2.
Click
OK
.
3.
Type the new IPv6 address (according to the network administrator).
Configuring the AppleTalk Zone
This option enables you to change the AppleTalk software network zone in which
your IC-304 print controller appears.
Note:
After an operating system reinstall, by default, the IC-304 print
controller is set to DHCP server configuration.
Note:
When prompted to restart your computer, click
No
. You will be
prompted at the end of the Configuration Wizard to restart your computer.
Note:
This option only applies to networks that contain Macintosh computers.
Summary of Contents for IC-304 Plus
Page 2: ......
Page 8: ...viii IC 304 Print Controller 2 0 for the bizhub PRO C6500 Printer Service Manual...
Page 147: ......
Page 148: ...Creo Color Servers...