3. DRIVING AND OPERATION
PIGB-183X 04 GXS 9005 / P 0218
38
ADJUSTMENT OF LIFTING HEIGHT
Fig. 3.6
When the screw
T
is loosened the cam track can be turned. If it is turned to the right,
the lifting height of the cutting unit is increased. If it is turned to the left, the lifting
height is reduced.
From the factory the cam track is adjusted so that the screw
T
is at a right angle to
the relief rod. This will be the optimal adjustment in most cases.
If you want another lifting height than the standard adjustment, do as follows:
1. Lift the cutting unit to the wanted headland position by activating the hydraulic
outlet. Pull the cord for the transport safety device, if necessary.
2. Loosen the screw
T
and turn the cam track until the ball bearing of the arm is
in the notch of the cam track.
3. Tighten the screw again.
P
R
1
2
-1
6
7
9
T
O
90
Fig. 3.6
Summary of Contents for GXS 9005
Page 2: ......
Page 16: ...1 INTRODUCTION PIGB 183X 04 GXS 9005 P 0218 16 ...
Page 18: ...1 INTRODUCTION PIGB 183X 04 GXS 9005 P 0218 18 PR11 1695 H B X L ...
Page 69: ......
