Kongsberg Seapath 320, Installation Manual, Page: 83 / 152

Installation Manual
M300-62/rev.2 67
Figure 42 Monitoring points view
To add a monitoring point, select the Add icon in the upper left
corner of the view and drag the symbol to the correct location on
the vessel. The selected monitoring point coordinates are shown
at the bottom of the view.
To get exact coordinates from AP to each monitoring point, each monitoring point has
to be measured or calculated based upon drawings or previously measured points, and
entered into the software manually. To delete a point, select the cross.
Note
If data shall be valid for NRP, it is not necessary to define a zero vector
since the data is default output in NRP.