Kongsberg SBP 29, Installation Manual

Page: 133 / 152

451253/A
133
Equipment handling
Observe these basic rules for transportation, storage and handling of units. In this
context, a
unit may be any large or small part of the system. It can be supplied as part
of the initial delivery, or as a spare part. The phrase box is used to describe all kinds of
cases, wooden or cardboard boxes etc used to hold the unit .
Supply power requirements
The supply voltage to the SBP 29 must be kept within ±10% of the installation’s nominal
voltage.
Maximum transient voltage variations on the main switchboard’s bus-bars are not to
exceed -15% to +20% of the nominal voltage (except under fault conditions).
Kongsberg Maritime strongly recommends that the SBP 29 Hydrographic Work Station
is powered through Uninterruptible Power Supply (UPS). The UPS must be large enough
to allow minimum 10 minutes operation. The system can then be switched off in a
controlled manner in case of power failures.
Environmental requirements
Vibrations
If the equipment is expected to be exposed to excessive vibration for extended periods,
special dampening precautions must be taken.
Temperature and humidity
All equipment, unless otherwise specified, must be protected from temperature extremes
and excessive humidity.
Equipment handling