Connector Pinout And Descriptions
4/13/2012
Kollmorgen
34
S200 Position Node Installation Guide
7.6 J2 – M
OTOR
P
OWER
C
ONNECTOR
Applicable Models: All except S21260-xNS (See TB1, above for this model).
1
4
(J2 Connector view from front of drive).
Pin
Description
J2-1
PE (Chassis Ground) on S200 AC Input Drives
BUS/CTRL GND on S200 DC Input Drives
Intended for motor ground and motor cable shield connection.
J2-2
Motor Phase W Output
J2-3
Motor Phase V Output
J2-4
Motor Phase U Output
Please refer to the product specifications section for appropriate wire sizing information.
Mating Connector Information
Screw Terminal Connector: 12 – 24 AWG Wire Range, Phoenix MSTB2,5/4-STF-5,08-BK
OR
Spring Cage Clamp Connector: 12 – 24 AWG Wire Range, Phoenix FKC 2,5/4-SFT-5,08-
BK
OR
Crimp Connector
Crimp Shell: 14-20 AWG Wire Range, Phoenix MSTBC 2,5/4-STZF-5,08-BK
Crimp Contact: 14-16 AWG Wire Range, Phoenix MSTBC-MT 1,5-2,5
Crimp Contact: 18-20 AWG Wire Range, Phoenix MSTBC-MT 0,5-1,0
Refer to www.phoenixcon.com
7.7 J3 – SFD F
EEDBACK
C
ONNECTOR
J3 is a 6-pin plugable IEEE 1394 style connector for the feedback device. Although this connector
mechanically accepts standard IEEE 1394 cables, it is electrically
not
an IEEE 1394 interface. The base
drive accepts either SFD (Smart Feedback Device) or Hall inputs.
1
2
3
4
5
6
Pins
Description
J3-1
+5 V Supply (200 mA) from drive
J3-2
+5 RTN 5V common
J3-3
SFD Communications -
J3-4
SFD Communic
J3-5 NC
J3-6 NC
Shell Shield
Connection
(J3 Connector view from front of drive)
Mating Connector Information
IEEE1394, Firewire type, 2.0 mm plug set
22 AWG Max., Molex 55100-0600
Refer to www.molex.com for assembly instructions.
