Kollmorgen BDS5, Installation And Setup Manual, Page: 118 / 150

A
PPENDIX
C - E
RROR
C
ODES
BDS5
C-2
The +5 volts is too low. This fault causes the microprocessor to blink the CPU light five times and then pause. The
BDS5 will not communicate or run the user program. Check the +10 VDC input into the BDS5 (Connector C4, Pin
4 or 8). If it is below 6.5 Volts for even a short time, this error will occur. This happens when the logic supply is
loaded too heavily, or when the line voltage (PSR4/5 Connector C1, Pins 2 and 3) is below 98 VAC (115 VAC less
15%).
C.2.2 BDS5 Faults
ERROR 10 "REMOTE OFF" SEVERITY 2
You attempted to execute an instruction that requires the hardware input REMOTE on the signal connector to be
active. This error breaks program execution.
ERROR 11 "OVER-TEMP" SEVERITY 3
The thermostat on the BDS5 heatsink opened, indicating overheating. Overheating may be caused by excessive
ambient temperature, obstructed airflow, broken fan, etc. Correct any such condition before resuming operation.
REMOVE ALL POWER BEFORE CHECKING THIS. If everything is functioning properly, a drive with a higher
current rating may be required. This error breaks program execution and disables the BDS5.
ERROR 12 "OVER-CURRENT" SEVERITY 3
The BDS5 detected an overcurrent. This can be caused by a shorted motor winding, a shorted power transistor, or a
short circuit in the wiring. Be sure to check all wiring before resuming operation. This error breaks program
execution and disables the BDS5.
ERROR 13 "OVER-SPEED" SEVERITY 3
The BDS5 determined that the speed of the motor was greater than the variable VOSPD. If this occurs occasionally,
it may be a nuisance fault that should be corrected by raising VOSPD by 5% or 10%. This error breaks program
execution and disables the BDS5.
ERROR 14 "POWER BUS" SEVERITY 3
The power supply high voltage bus has either an overvoltage fault or an undervoltage fault. See Chapter 3 for more
information. This error breaks program execution and disables the BDS5.
ERROR 15 "COMP BOARD" SEVERITY 3
You attempted to enable the BDS5 with the compensation board removed. Replace the compensation board. This
error breaks program execution.
ERROR 17 "FEEDBACK LOSS" SEVERITY 3
The BDS5 has detected that one or more wires to the resolver have been broken, or the resolver connector has been
removed. This error breaks program execution.
ERROR 18 "BAD TL" SEVERITY 3