Kohler CV11-16, Service Manual

Page: 134 / 150

11.10
Section 11
Reassembly
2. Reattach the fan to the fl ywheel, using the
spacers and hex. fl ange screws, or shoulder
screws. See Figure 11-28. Torque the hex. fl ange
screws to
9.9 N·m (88 in. lb.) . On electric start
models, with the domed fan, proceed through
step 4 before reattaching the fan.
Figure 11-28. Installing Fan to Flywheel.
3. Place the fl ywheel over the keyway/crankshaft.
Retractable Starter Models: Install grass
screen, drive cup, plain washer (fl at side towards
the drive cup), and the hex. fl ange screw. See
Figure 11-29.
Fan
Hex. Flange Screws (4)
Spacers (4)
Flywheel
Drive
Cup
Hex. Flange
Screw
Grass
Screen
Plain Washer
Figure 11-29. Installing Flywheel (Retractable
Starter Models).
Electric Start Models: Install the plain washer
and the hex. fl ange screw. See Figure 11-30.
Figure 11-30. Installing Flywheel Retaining Screw
and Washer (Electric Start Models).
4. Hold the fl ywheel with a strap wrench or holding
tool (see Section 2) and torque the hex. fl ange
screw to
66.4 N·m (49 ft. lb.) . See Figures 11-31
and 11-32.
NOTE: Always use a fl ywheel strap wrench or
fl ywheel holding tool to hold the fl ywheel
when tightening the fl ywheel fastener. Do not
use any type of bar or wedge between the
cooling fi ns or fl ywheel ring gear, as these
parts could become cracked or damaged.
Fan
Washer
Hex. Flange Screw
Figure 11-31. Torquing Flywheel Fastener
(Retractable Starter Models).
Torque Wrench
Strap
Wrench