Chapter 6
MDC-3560P/3510P Series
USING THE MENU
6-24
93142002-01
6.3 SYSTEM SETUP MENU (Setting up functional parameters)
To activate the SYSTEM SETUP MENU, turn off the radar first. Then press and hold
the ENT key and press the POWER key. The following SYSTEM SETUP MENU will
appear with default values shown.
Table 6.1 SYSTEM SET UP MENU with default values shown
LOG
PULSE
RATIO
100
GYRO
GEAR
RATIO
36X
SERIAL
GPS
FORMAT
IEC61162-1
SERIAL COMPASS FORMAT
IEC61162-1
SERIAL
LOG
FORMAT
IEC61162-1
TRAIL MODE
PAINT
OFFCENTER
MODE
CURSOR
TRUE MOTION RESET MODE
OPPOSITE
KEY
CLICK
SOUND
ON
KEY
CLICK
FREQ.
4000
Hz
ALARM BUZZER FREQ.
4000 Hz
ALARM OPERATION MODE
VARIABLE
TOTAL
HOUR
METER
XXXX
HOUR
TX
HOUR
METER
XXXX
HOUR
To change above settings, use the following procedure.
(1) Move the Joystick upward or downward to select a parameter to change.
(2) Press the ENT key to set up the selection ready status. The highlighted parameter
will blink accordingly.
(3) Move the Joystick right or left to select the value.
(4) Press the ENT key again to fix the entry.
To exit from this menu, turn off the radar and then turn the radar on for further use.
6.3.1 LOG PULSE RATIO
This menu is used to set up the incoming log pulse ratio, which is fed to the Gyro
Interface unit, type KSA-08 built into the display unit.
The following pulse ratios can be selected: 100, 200, 400 and 500 pulses/nm.
6.3.2 GYRO GEAR RATIO
This menu is used to set up the gyro gear ratio used, which is fed to the Gyro Interface
unit, type KSA-08.
The following pulse ratios can be selected: 36X, 90X, 180X and 360X