Chapter 6
MDC-3560P/3510P Series
USING THE MENU
6-12
93142002-01
6.1.16.8 WARNING LIMIT (Setting the warning limit of CPA and TCPA)
This function is used to set up the limit at which the warning alarm for CPA and TCPA
is activated. Use the following procedure for set up.
(1) Highlight the item and press the ENT key for the selection ready status.
(2) Setting ranges for CPA and TCPA are as follows:
CPA: 0.00 NM to 19.9 NM.
TCPA: 1 Minute to 63 Minutes
6.1.16.9 TARGET ALL CLEAR (Clearing all target plots)
Using this function, all target plots can be cleared. Highlight the “TARGET ALL
CLEAR” sign and press the ENT key.
6.1.16.10 ID DISP (Displaying Target ID Number)
Using this function, the target ID number can be tagged on each displayed target.
Highlight the ON or OFF sign and then press the ENT key for the selection ready
status. Press the Joystick left or right to select ON, and press the ENT key.
6.1.16.11 Correcting the latest plotting position
In case you find a wrong plotting and need to correct it, carry out the following steps:
(1) Press the TARGET key on the control panel.
(2) Move the Joystick to move the cross cursor on to the new plot point.
(3) Press the UPDATE key. Wrong plot will be corrected as shown below.
After correction
Before correction
Wrong plot
Corrected plot
Figure 6.5 Correcting the plotting position
