Koden MDC-2900, Operation Manual

Page: 125 / 191

Chapter 4 General operation (Menu) MDC-2900 Series
0093129012-06 4-22
DETAIL
PI MODE
Selection values: CURSOR, LINE
This is to select an operation mode of the PI.
CURSOR: This is the mode for simultaneously operating of lines in parallel.
Distance between lines and their bearing cannot be changed independently.
The length of the lines cannot be changed.
LINE: Refer to “
Measure distance/bearing (PI: Parallel index line)
” (page2-17)
PI CURSOR
Selection values: NORMAL, 1, 2, 3, 4, 5, 6, 7
This is to select the number of display lines when parallel cursor mode is set in [CURSOR].
At NORMAL, only the number of range rings is displayed (The number of range rings depends on the
ranges used.)
VRM1 UNIT
Selection values: NM, km, sm, kf, RANGE LINK
This is to set the display unit for range for VRM1.
The unit of range for other than VRM1, VRM2 and PI can be also set in [Range unit].
Refer to “
RANGE UNIT
” (page4-2)
VRM2 UNIT
Selection values: NM, km, sm, kf, RANGE LINK
This is to set the display unit for range for VRM2.
The unit of range for other than VRM1, VRM2 and PI can be also set in [Range unit].
Refer to “
RANGE UNIT
” (page4-2)
PI UNIT
Selection values: NM, km, sm, kf, RANGE LINK
This is to set the display unit for range for PI.
The unit of range for other than VRM1, VRM2 and PI can be also set in [Range unit].
Refer to “
RANGE UNIT
” (page4-2)