Koden MDC-2900, Operation Manual

Page: 130 / 191

MDC-2900 Series Chapter 4 General operation (Menu)
0093129012-06 4-27
DISP GROUP AREA
Selection values: OFF, 1 to 20
· This is the function to select blocks of the area to be displayed.
· This designates the block to be displayed out of 20 blocks in AREA.
Refer to “
EDIT AREA
” (page4-28) to edit.
It is possible to set within AREA the echo entering alarm or the echo leaving alarm.
Refer to “
MAP AREA
” (page4-6) to edit.
EDIT COAST LINE
· This is to map and edit COAST LINE.
· Edit operation can be performed after designating block number.
· This function is valid by inputting 2 or more positions and each input positions are linked with line.
· Up to 50 points can be input per 1 block.
· Set “DIVIDE” ON at the last point to draw multiple lines in a block.
· Pay attention that “INSERT” will erase 50th point.
Refer to “
DISP GROUP COAST LINE
” (page4-25) for setting display/non display.
*About EBL1/VRM1 input.
Latitude and longitude can be input by using EBL1 and VRM1.
Switch on [EBL1/VRM1] and put the two intersections at the position where to input.
Select [EBL1/VRM1 Input] and press [ENT] key to input.
EDIT NAV LINE
· This is to map and edit NAVLINE.
· Edit operation can be performed after designating block number.
· This function is valid by inputting 2 or more positions and each input positions are linked with line.
· Up to 50 points can be input per 1 block. 50 points can be divided into A and B having 25 points each.
Divide input into A and B to make NAV LINE wider.
· Pay attention that “INSERT” will erase 50th point.
Refer to “
DISP GROUP NAV LINE
” (page4-26) for setting display/non display.
Refer to “
EDIT COAST LINE
” (page4-27) for about EBL1/VRM1 input.