Koden MDC-2900, Operation Manual, Page: 149 / 191

Chapter 4 General operation (Menu) MDC-2900 Series
0093129012-06 4-46
FORMAT
Selection values: 61162-1, 61162-2, NSK
This is to set up communication format of NAV, EPFS, SDME and GYRO connectors.
61162-1: Baud rate 4800
61162-2: Baud rate 38400
NSK: This is the format for NSK only.
KGC-1 SET
Initialization and compensation are available.
At the time of installation, initialization is a must.
NSK SET
Initialization and compensation are available.
At the time of installation, initialization is a must.
SENTENCE SET
Selection values: OFF, ON
This is a function to select use or nonuse of input of ship bearing, ship speed, and ship
latitude/longitude.
When there is no input and a radar is used alone, all shall be switched off.
Low or doubtful integrity information display
Figure values displayed on the screen turn red when the input data is Invalid.
Certain functions such as TT (ARPA), AIS, etc. cannot be used when the information of ship’s bearing,
speed or position at the upper right of the screen are displayed in red.
Functions are not available even if input sentence is correct unless talker device, status and mode
indicator are valid.
OS PROFILE (Cannot use while transmitting)
This is to set up own-ship profile and ANT location.
A, B, C and D designate distance of profile from CCRP.
“dx”, “dy” designate distance of ANT location from CCRP.
Refer to “
Setup own ship profile (Cannot use on transmitting)
” (page1-5)