Koden MDC-2900, Operation Manual

Page: 51 / 191

Chapter 2 Basic operation (Panel) MDC-2900 Series
2-20 0093129012-06
Measure distance/bearing (ERBL: Electronic range and bearing line)
The given point of distance and bearing can be measured with the cursor as follows.
Measurement of distance and bearing from reference point can be performed by adjusting cursor to
reference point position.
Refer to “
Setup own ship profile
” (page1-5) to setup reference point.
Refer to “
Bearing mode set up
” (page3-12) to setup bearing mode.
[Bearing mode] can be changed directly in the lower light of the screen, with trackball and [ENT] key,
without using menu function.
1
Push [ERBL] key and ERBL is displayed.
ERBL
000.0
°
1.00
NM
ERBL
REL
CURSOR
Target B
Target A
2 By adjusting Focus CURSOR to the target A, the measurement of the distance and bearing from
the target A to the target B can be obtained by using [VRM] knob and [EBL] knob.
ERBL
304.2 °
2.82
NM
REL
Own ship
3
Pressing [ENT] key (while pressing [OFF] key) returns CURSOR to the reference point position.
Thereafter, it is possible to measure the distance/bearing from the reference point position.
ERBL
304.2
°
2.82
NM
REL
OFF
OFF key
ENT
ENT key