Kodak VERSAMARK DP5120, Installation Manual

Page: 37 / 82

Installation Guide 3-5
Chapter 3. Printer Installation
Fluid Container Installation
Ink Bottle
Use the following procedure to install the ink bottle:
1. Open the fluid compartment door and locate the fluid bottle
connections (see Figure 3.4).
Note: See the diagram of this procedure on the label inside the fluid
compartment door and refer to the instructions shipped with the ink.
Figure 3.4 Ink bottle compartment, DP5122 printer
2. Carefully open the cardboard container and remove the cap from the
bottle.
Note: Retain the cap to put back on the empty bottle when it is removed.
3. Install the ink container in the right position between the metal
supports with the cutouts in the container facing out (toward the door).
Hint: Pull up on the bottle neck while sliding it into position.
4. Make sure that the flower-shaped collar of the bottle is above the
metal support arm.
Caution: If the bottle collar is left under the support arm, the bottle (bladder) will
collapse inside the container and block the bottom of the ink supply tube.
This problem produces a spurious ink bottle empty error.
5. When you position the container, listen for the click of the quick-
disconnect. The click confirms that the ink supply connection has
sealed properly.
6. Press down on the locking plate until it punctures the bottle seal and
locks the container into place.
7. Continue with the “Replenisher Bottle” procedure.
Ink bottle connection
Replenisher bottle connection