Kodak VERSAMARK DP5120, Installation Manual

Page: 18 / 82

2-2 DP5000 Series Printers
Chapter 2. Unpacking
Printer
Removing Packaging
Use the following procedure to remove the pallet packaging.
1. Use a forklift or hand truck to move the pallet as close as possible to
the final location intended for the printer.
2. Position the pallet where there is 3 ft. (1 m) of clear working space on
all four sides.
3. Cut the shrink-wrap and remove it from the pallet.
Caution: Do not cut into the boxes. Use a box knife or other short-bladed tool and
cut where pallet contents do not touch the shrink wrap.
4. Remove the smaller boxes from the pallet and set them aside for later
unpacking.
Note: A typical printer shipment includes three extra boxes (see “Printer
Inventory”). Figure 2.1 shows the pallet with the shrink wrap and smaller
boxes removed.
Figure 2.1 Printer on shipping pallet
5. Cut the bands on the printer box.
6. Remove the box lid.
7. Remove the printer accessories box from inside the printer box.
Note: Set the accessories box aside for later unpacking.
8. Cut open the end (short side) of the box at the back of the printer.
a. Access the back of the printer where the handle is located.
9. Fold down or tear off the cut side of the box.
10. Remove all the packaging from the pallet and the area around the
printer.
Note: Leave the packaging on the printhead housing at the end of the umbilical.
11. Continue with the shipment inventory.