Kodak VERSAMARK DP5120, Installation Manual, Page: 54 / 82

4-2 DP5000 Series Printers
Chapter 4. System Installation
Controller Positioning
3. Roll the cabinet by pushing the front (see Figure 4.2). The enclosure
is easier to control if pushed and steered from the front because the
front casters swivel, and the rear casters are fixed.
Figure 4.2 Enclosure ready for positioning
4. If possible, position the system enclosure where you have at least 3
feet (1m) of clearance in front and in back.
Note: Less clearance makes cabling the system difficult.
5. Lock the casters.
6. Route the umbilical.
Controller Positioning
Use the following procedure to position the controller components on top
of the system enclosure:
1. When the cabinet is properly positioned, check that the casters are
locked to ensure that the cabinet does not roll while components are
being placed on top of it.
2. Check that all boxes were brought from the location where the
shipping pallet was unpacked.
3. Unpack the controller PC and place the processor chassis on top of
the enclosure.
4. Unpack the monitor and place it on top of the controller PC (see
Figure 4.3).
Caution: Take all precautions recommended by the monitor manufacturer to
protect the monitor from dust.
5. Unpack the keyboard and place it on top of the enclosure. The
keyboard skin can be installed, if desired.
6. Unpack the mouse and mouse pad and place them on top of the
enclosure.
Casters, unlocked
Enclosure front