Kodak VERSAMARK DP5120, Installation Manual

Page: 30 / 82

2-14 DP5000 Series Printers
Chapter 2. Unpacking
Printheads
DH5240 Printhead
Use the following procedure to unpack the 1", 240-dpi printhead:
1. Take the printhead box to the location where the printer is to be
installed (and the second, spare printhead box, if one was included in
the shipment).
2. Open the outer (printhead shipping) box.
3. Remove the following contents of the box (see Figure 2.6):
• Inner printhead box
• Printhead return form (0113477) and shipping label (0193675)
• Ink card (0113590)
• Test pattern print sample.
Note: The printhead Replacement Instructions (0114252-602) and Packing
Instructions (0114253-602) are in the printer or system installation kit.
4. Note the serial number on the inner box label. This number should
match the printhead serial number on the outer box label. Record this
number for the installation report.
5. Open the inner box.
Caution: Cut the tape carefully using a box knife or other short-bladed tool to avoid
cutting the printhead capsule inside.
6. Remove the printhead capsule carefully to avoid damaging the
protruding components (catcher flex cable assembly).
7. Open the capsule and remove the printhead assembly.
Note: Four Phillips screws secure the capsule.
8. Store the printhead assembly in a safe location near the printer until
you are ready for printhead installation.
9. Retain the printhead packaging (outer box, inner box, and capsule).
Note: This packaging must be used if the printhead is returned.
10. Continue with the printer or printing system installation procedure.
Figure 2.6 DH5240 printhead, capsule inside inner box