AZURA® Detector RID 2.1L / RID 2.1L HighFlow Instructions V6750
12
Product information
Process
1.
Set-up the package in such a way that you can read the label.
2.
Cut the tape with a utility knife and open the package.
3.
Lift off the foam pad. Take out the accessories kit and the manual.
4.
Open the accessories kit and check the scope of delivery. In case
any parts are missing, contact the Technical Support.
5.
Hold the device from below, lift it out of the packaging and place it
on its feet. Do not hold onto the front cover.
6.
Check the device for transport damage. In case of damage, please
contact the technical support.
7.
Set up the device at the operation site. Remove the protective foil.
Store packaging and keep the included packing list for repeat orders.
5.3
Power supply
Electronic defect
Electronic hazard when using an identically constructed power adapter
from another manufacturer.
Only use spare parts and accessories from KNAUER or a company
authorized by KNAUER.
Note:
Make sure that the power adapter and power cables meet the
requirements (see 11.3 on page 41). Removable power cables must
not be replaced by other types of cables.
The detector is intended for use with AC power networks of 100-240 V.
Only the supplied power cable is to be used to connect the device to
the mains supply.
Make sure that the power plug on rear of the device is always accessi-
ble, so that the device can be disconnected from the power supply.
6.1
Connecting the leak management
The leak management consists of the leak sensor and the drainage
system. The drainage system ensures that escaping liquids flow into a
waste bottle. If there is too much liquid, the red LED starts flashing. Both
the device and the data acquisition via chromatography software are
stopped.
Remove the front cover.
Next steps
6. Initial startup
Prerequisites
