KLS Martin CEMOR, Mounting Instructions

Page: 52 / 84

Mounting Instructions
0B
CEMOR Monitor Suspension System
52 Revision 1
WARNING
Risk of injury from falling TFT screen!
The 4 Allen cylinder screws M4 x 20 mm DIN 912 must be adapted to the TFT screen. If
the length of engagement is not sufficient, the TFT screen can fall down. If the engagement is
too deep, the TFT screen can be damaged and rendered unusable:
•
Make sure the screws engage at least 5 mm deep, even where a deeper thread insert is
used.
•
Observe the information by the manufacturer of the TFT screen regarding screw lengths
and tightening torque.
•
Place 1 contact washer D4,1 on each of the 4 cylinder screws .
•
Screw the 3D VESA mount onto the TFT screen using 4 cylinder screws . Screw
2 cylinder screws through the drill holes , not the elongated holes.
•
Tighten 4 cylinder screws according to the instructions provided by the manufacturer of
the TFT screen.
Make sure the 3D VESA mount is safely in place:
•
The 3D VESA mount must butt against the TFT screen.
•
The 4 cylinder screws must be of appropriate length and tightened according to the
instructions by the manufacturer of the TFT screen.