KLS Martin CEMOR, Mounting Instructions

Page: 29 / 84

Mounting Instructions
0B
CEMOR Monitor Suspension System
Revision 1 29
5 Commissioning
5.1 Initial Commissioning and Handover
Initial Commissioning
The entire suspension arm system and CEMOR have to be correctly commissioned after
installation has been completed.
Functional check
The suspension arm system and CEMOR must not be used on the patient before the operator
or a person authorized by the operator has performed a function check at the operating site,
and the persons assigned by the operator have been instructed.
This is deemed fulfilled if:
•
the functional safety of the suspension arm system and CEMOR has been ensured;
•
the maximum load-bearing capacity (payload) has been reliably determined and posted on
CEMOR in the form of a sticker;
•
the flawless function was confirmed by the operator during initial commissioning and
documented in a declaration of handover.
Handover
The following items must be complied with for the handover to the operator:
•
The suspension arm system and CEMOR must be handed over to the operator in their
inspected state.
•
The handover must be done in writing and confirmed by the operator.
•
The operator must be instructed in the function and operation of the maximum load-
bearing capacity (payload) upon handover.
•
As part of the handover, the operator must be made familiar with the function, operation,
cleaning and disinfection of the suspension arm system and CEMOR.
•
As part of the handover, the operator must also be instructed in the approved adjustment
work according to the supplied Instructions for Use.
•
Upon completion of the instruction, it must be documented in an instruction report that the
operator/user has understood the special actions required for proper use.