Brick Liner Installation Guide
The installation procedure for the Liners is common between the brick and porcelain. One should
note however, that no matter which is installed it is imperative that the panels be positioned tightly
against the walls of the firebox to ensure proper combustion and operation.
CAUTION: Before operating the appliance, any screws removed from the firebox should be
returned to the original position to ensure proper sealing.
1.
Remove the glass door (see page 1
8
).
2.
Remove the Grate bar by unfastening the two [2] screws holding it in.
3.
Remove just the burner tube by sliding it towards the right hand side.
4.
If the Upper Clips [2] and Lower Panel Brackets [2] are preinstalled, then remove them.
5.
Tilt the Back Panel backwards and slide it into place. The Back Panel should rest on the Air
Restrictor.
6.
Tilt the Side Panels sideways and slide it into the firebox. Rest the panels on the Firebox
Bottom and tightly up against the wall.
7.
Slide the Side Panels upwards so that the angled face is flush with the angled face of the fire-
box. Ensuring that the Back Panel is pinned securely, install the Lower Panel Brackets to prop
the Side Panels in place.
8.
Slide the Upper Clips so that the Side Panels are tightly secured onto the side walls of the
firebox.
9.
To remove simply reverse these steps.
Figure 21 - Brick installation procedure.
25
Summary of Contents for Marquis Serenity MQZDV1917
Page 10: ...General Framing Installations Figure 5 General framing installation 10...
Page 31: ...Gas Conversion for Modulator PART C WARNING WARNING 31...
Page 34: ...Configuration 1 Basic manual HI LO and manual ON OFF capabilities 34...
Page 35: ...Receiver Module 584 523 521 221 1001 P221SI Receiver Module 584 523 521 221 1001 P221SI 35...
