Burner Removal/Servicing Guide
CAUTION: BEFORE STARTING REMOVAL OF PARTS TURN OFF GAS SUPPLY AND DISCONNECT
ALL ELECTRICAL SUPPLIES.
ALL WORK SHOULD BE PERFORMED BY A QUALIFIED AND CERTIFIED TECHNICIAN
1.
Remove Glass Door, Logs, Rocks, and Embers. Remove the Grate Bar Assembly by remov-
ing the screws located at G1 and G2. Remove the Burner Tube by removing the hold-downs
located at B1 and B2. (See Figure 20.)
2.
Remove the nine [9] screws mounting the Burner Pan assembly to the firebox. Tilt the pan for-
ward and remove it from the unit.
3.
Installation is the reverse of these steps.
NOTE: Before reinstallation, ensure that all old sealant material is scraped off and removed from the fire-
box bottom and burner pan. Verify that the sealing area is clean, and free of any grease and debris. Apply
a fresh bead of high temperature sealant (e.g. Mil Pac) to the sealing area and ensure that there is a prop-
er seal after the reinstallation.
WARNING: FAILURE TO PROPERLY SEAL THE FIREBOX WILL RESULT IN IMPROPER
COMBUSTION AND/OR LEAKAGE OF TOXIC COMBUSTION GASES.
Figure 20 - Burner removal diagram.
WARNING: FAILURE TO POSITION THE PARTS IN ACCORDANCE WITH THESE
DIAGRAMS OR FAILURE TO USE ONLY PARTS SPECIFICALLY APPROVED WITH
THIS APPLIANCE MAY RESULT IN PROPERTY DAMAGE OR PERSONAL INJURY.
24
Summary of Contents for Marquis Serenity MQZDV1917
Page 10: ...General Framing Installations Figure 5 General framing installation 10...
Page 31: ...Gas Conversion for Modulator PART C WARNING WARNING 31...
Page 34: ...Configuration 1 Basic manual HI LO and manual ON OFF capabilities 34...
Page 35: ...Receiver Module 584 523 521 221 1001 P221SI Receiver Module 584 523 521 221 1001 P221SI 35...
