Kingsman Marquis Serenity MQZDV1917, Installation Instructions Manual

Page: 18 / 50

How to Install the Glass Door
Figure 15 - Glass door installation guide.
Glass Cleaning
Removal Guide
Cautions and Warnings
Glass Replacement
NOTE: Model Series MQZDV1917 must use Robax ceramic, or coated Neaoceram, glass that is
a minimum of 5mm thick but cannot exceed 6mm.
Remove the Arch Door (Please refer to page 19 ). Release the two [2] Lower Door Latches by
pulling them out and over the Door Tabs. Unscrew the Upper Door Latches from the Glass Door.
Slide the Door out and over the Slide Tabs. To install the Glass Door, simply reverse these steps.
It will be necessary to clean the glass periodically. During start-up, condensation (which is normal)
forms on the inside of the glass and causes dust, lint, etc. to cling to the glass surface. Also, initial
paint curing can deposit a slight film on the glass. It is therefore recommended that initially the
glass be cleaned two or three times with non-abrasive common household glass cleansers and
warm water. After that, the glass should be cleaned two or three times a season depending on the
circumstances.
To replace glass, clean all materials from the door frame. Scrape off old silicone all the way down
to the metal. Using high-temp silicone [rated up to 500°F (260°C)] apply a continuous bead of
approximately 1/32” to all four [4] sides of the frame. With the frame resting on a flat surface, insert
the new glass with a new gasket. Gently press the glass into the silicone. Be careful not to use
excessive force on the glass. Let the silicone dry for approximately 15-20minutes.
Warning and Cautions.
• Do not clean when the glass is hot.
• Do not use abrasive cleaners.
• Using a substitute glass will void all product warranties.
• Do not strike or abuse glass. Care must be taken to avoid breakage of the glass.
• Do not operate this fireplace without the glass front or with a broken glass.
18