How to Install the Arch Door
Figure 16 - Arch Door mounting tab locations.
1.
Ensure that the Lower Access Panel is in the OPEN position. Make note of the four [4]
Mounting Tabs located on the unit [T1-T4], and the four [4] Mounting Slots on the Arch Door
[S1-S4] (see Figure 16).
2.
Slide the Arch Door into the unit as shown in Figure 17. Ensure that the upper portion of the
frame is IN FRONT of the Upper Mounting Tab, and the lower portion is BEHIND the Lower
Mounting Tab.
Figure 17 - Arch Door installation.
3.
Swing the right side of the Arch Door into the unit. Position the Upper Mounting Tab so that it
is sitting at the base of the Guide Ramp.
4.
Slide the Frame upward, along the Guide Ramp, and rest the Lower Mounting Slots [S1 and
S2] onto the Lower Mounting Tabs [T1 and T2]. NOTE: Check to ensure that the Upper Tabs
T3 and T4 are inside the Slots S3 and S4.
5.
To remove the Arch Door please reverse these steps
19
Summary of Contents for Marquis Serenity MQZDV1917
Page 10: ...General Framing Installations Figure 5 General framing installation 10...
Page 31: ...Gas Conversion for Modulator PART C WARNING WARNING 31...
Page 34: ...Configuration 1 Basic manual HI LO and manual ON OFF capabilities 34...
Page 35: ...Receiver Module 584 523 521 221 1001 P221SI Receiver Module 584 523 521 221 1001 P221SI 35...
