KINGFISHER
O W N E R ’ S M A N U A L
w w w . k i n g f i s h e r b o a t s . c o m
56
The back rest on the 25’ and 27’ models can be turned around so that the seat faces the
table. To do this,
Lift up slightly on the back rest and push the legs of the backrest firmly towards the bow
of the boat.
Lift up on the backrest and remove it from the seat cabinet.
Rotate the backrest 180 degrees and re-insert it into the cabinet through the slots on the
seat cushion. Line up the slots in the backrest legs with the stainless steel pivot bar that
is visible in the cabinet through the seat cushion slots.
Once that the backrest leg slots have been positioned over the pivot bar, slide the
bottom of the legs toward the bow of the boat.
The backrest will locate into position when the legs are pushed all the way forward.
Live well
To operate the live well:
Firmly insert the supple end of the live well drain tube into the drain in the live well.
Ensure that the ball valve on the live well water pick up is open. The ball valve is
located in front of the main bilge pump slightly to the port side.
IMPORTANT:
Whenever the live well is not being used, the water pick up ball valve
should be in the off position.
Ensure that battery power is turned on.
Turn on the live well pump by operating the switch located underneath the port side
rear gunnel.
The water level in the live well will climb up the drain tube until it can drain into the
top of the tube and out of the boat. Water will continually pour into the live well and
drain out of the drain tube until the live well pump is turned off. Water from the drain
tube is evacuated out of a through hull located at the rear of the boat (see through
hull layout).
To empty the live well of water, simply turn off the pump and remove the tube.
If the live well pump fails to work,
Confirm that the battery switch is turned on.
Confirm that the battery system is fully charged and functioning and that all wires
leading to the batteries are secured firmly to the battery posts.
Check that the main 30 amp fuse and the fuse under the dash have not blown.
Once the above has been checked, if the live well pump is still not working, close the
ball valve and consult a Kingfisher dealer.
