Keysight Technologies S9100A, Startup Manual

Page: 27 / 107

3 Review Hardware Components
S9100A 5G Multi-Band Vector Transceiver, Startup Guide 23
3. 2. 4 Connectors, M9037A PXIe Embedded Controller
Status LEDs
PWR (Green) On, indicates power supply
to embedded controller is good.
SSD (Amber) Flashes when Solid State Drive is active.
Link (Green) Indicates PCIe Link status:
Off = No link;
Blinking @ 1 Hz = Gen1 speed
Blinking @ 2 Hz = Gen2 speed
On steady = Gen3 speed
LAN (White),
USR (Grey) Both LEDs are reserved for Keysight use only.
Video/Dual Display Ports
Connectors Two, Dual Mode Disp+ connectors can
support either a DisplayPort or DVI-D monitor
USB 2.0 and 3.0
Connectors Four, USB 2.0 (Type A)
Connectors Two, USB 3.0
LAN 1 and LAN 2
Connectors Two, 10/100/1000BASE-T
(RJ-45) Gigabit Ethernet ports
LAN Connector
Top LED (Amber)
LAN Connector
Bottom LED (Off)
Bottom LED (Green)
Bottom LED (Amber)
LAN Connectors,
Top and Bottom
LEDs (Off)
Active, blinks if accessing IO
LAN Speed: 10 Mbps
LAN Speed: 100 Mbps
LAN Speed: 1000 Mbps
Network link not established
or system is powered off.
LAN RST (Reset) Button Reserved for Keysight use only.
Trig (PXI Trigger In/Out)
Connector SMB (m) snap-on,
bi-directional trigger connector for routing an
external trigger signal to/from PXI backplane
GPIB
Connector GPIB (Micro-D 25-pin)
PCIe
Connector x8 Gen 3 PCIe IPASS connector for controlling
a second PXIe or AXIe chassis or RAID storage