Keysight Technologies S9100A, Startup Manual

Page: 103 / 107

8 S910xA SCPI Programming Commands
S9100A 5G Multi-Band Vector Transceiver, Startup Guide 99
Default 50e+6
[:SOURce]:CONF[:POWer]:OFFSet <num>
[:SOURce]:CONF[:POWer]:OFFSet?
The source configure power offset command sets the loss between the source output
port and the DUT input port.
This value ends up being set as the power offset on the primary source for the
intended signal. A loss between the source output port and the DUT input port would
be entered as a negative number. For example, with an over the air loss of 50 dB, a
value of -50.0 should be entered with this command.
Default 0 dB