GS42AVE/GS44AVE connections
V
C
is a voltage input.
is a current input (with V to C for current range)
-
is the -ve voltage
Ranges available:
0 - 100 mV
0-20 mA
0 - 1 VDC
4-20 mA
0 - 10 VDC
Each input is a differential input.
Inputs are not isolated.
Note; When renewing batteries and especially if transmitter is no longer operating ensure you allow
one minute with no batteries connected before installing new batteries. This is to ensure transmitter
performs a power-on reset.
9VDC
supply
Eltek TU1026 - User Instructions for GS42AVE/GS44AVE
Page 1 of 2
The
is intended for use with any sensor where an averaged rather than
instantaneous value at the time of transmission is required. The averaging technique includes values
that can change during a transmission interval.
At the point of transmission the averaged value of the last 30 values, sampled every 10 seconds per
channel, is sent.
GS42AVE/GS44AVE
Connector 1
0
+
Connector 2
0
+
(GS42AVE and GS44AVE)
is external 9VDC -ve (e.g MP9U)
is external 9VDC +ve
(GS44AVE only)
( is No connection, is No connection)
Connector 2 is not available on the GS42AVE.
Configuration
socket. 3.5mm
“stereo" jack
socket.
Not
fitted
Battery
supply fuse (1A).
SK4 - factory
use only
Red jumper J4
(default setting)
GS42AVE/GS44AVE interior components
External power supply connected
*For serial numbers prior to this, the 5V and 12V are swapped and the external supply link is not provided.
(Applicable to transmitters with serial numbers above 14889*)
GS42AVE
GS44AVE
