Keylogbook
– Getting Started Guide
12/09/2013
9
To check the remaining battery power while running on the battery
1. Press the battery gauge button on the left side of the tablet. Battery gauge lights
illuminate on the front of the tablet when the tablet is running on battery.
2. Count the number of battery gauge lights. Each light represents about 20 percent
increments of a full charge as shown:
Charging the tablet in the vehicle
Connect the cigarette adaptor into the standard socket on the left hand side of the tablet.
Charge a battery pack
The battery pack is being charged when Keylogbook is connected to any of the specified power sources.
Keylogbook can charge the battery pack while in use. While the battery is charging, the red LED on the LHS is lit
this will go green once fully charged.
The first time, or after a long time in storage, Keylogbook takes up to 12 hours to be fully charged. Normally the
battery is charged in 6 hours.
Battery and power management tips
• To lengthen the battery’s usable life, use AC power when you can. The battery charges
automatically when the tablet runs on AC power.
• For optimal battery life, use AC power when using a USB device such as a DVD player or
external hard disk drive.
• When running on battery power, place the system in hibernate or sleep mode if you are
going to leave it unattended for more than a few minutes.
• Remember that the display, processor, wireless cards and accessories all draw on the
battery, so adjust properties and disable unused accessories while running on battery
power.
• Condition your battery once a month. To condition it, run the tablet on battery power
until the battery’s charge level drops below 20 percent.
• When running on battery power, adjust the display to a dimmer setting and enable
Dynamic.
It is important to note that when you turn the unit on you need to press and
hold the On/Off button for one or two seconds. However when you are
bringing it back from standby you only need to press the button. Pressing
and holding the button or repeatedly pressing the button while it is in standby
mode immediately starts the shutdown sequence.
Touch Screen