Keylogbook
– Getting Started Guide
12/09/2013
14
1.
Printer Overview
The printer and tablet are paired prior to despatch and therefore only work when used together, should labels fail to
print, go to the label printing area via the options button and select reset printer settings. Should you still have
problems please consult the printers own troubleshooting guide
The printer is charged using the 12V cable supplied. When the printer is not in use it will enter sleep mode and will
remain operational for over a day. We recommend that you charge the printer at the end of each day.
Ink cartridges are not required, as the printer uses thermal printing methods. Thermal printing uses special heat
reactive paper rather than ink.
To load labels, press the push open button on the top of the printer and place the labels in as shown below. Use
the lever to ensure that the labels are held firmly in the centre of the printer, this will ensure the full label is printed.
The labels should face the front of the machine and feed from the bottom of the printer, (please note the labels are
not inserted into any slots) close the lid with a label sticking out of the printer they will align themselves
automatically when the first label is printed.
Additional labels can be ordered from the KeyLogbook supplier on 01295670990 only the correct sized labels will
work with KeyLogbook programme.
The printer care instructions are shipped in the Keylogbook carry case.
Please note
The printer is very rugged and will withstand everyday use, however as with all printers it is not waterproof and
should be protected from water at all times
Set up Bluetooth
Keylogbook has a built-in Bluetooth adapter which provides short-range wireless