Kessel 010-694, Instructions For Installation, Operation And Maintenance

Page: 77 / 264

Maintenance
77 / 264 03/2015
6.2.1 6.2.1 Maintenance card
Inspection/maintenance Ecolift XL
Please note the safety instructions
Building description
Building
Street
Postcode, city
Contact
System variant Mono
❏
Duo
❏
Serial number
Pump type 1
❏
2
❏
Inspection: Once a month by the operator:
No. Test Done record
yes no
1 Check the display of control unit 1 Comfort Plus for possible fault messages
2
Manual function test on Comfort Plus and on control unit for redundant valve if present,
close flap A (sewer side) (using flap test hand symbol)
Make sure of inflow (clear water)
➞
wait to see if the pump starts working
3
Manual function test on control unit for redundant valve if present
close flap B (house side) (using flap test hand symbol)
Make sure of inflow (clear water)
➞
wait to see if the pump starts working
A rising level can be seen on the display. Inlet until switch-on point 1 or switch-on point 2 has been reached, then
pump operation starts.
“On” level: ______________________
“Off” level: ______________________
Since pumps 1 and 2 pump alternately, always wait two operating cycles.
4
Test compressor set
➞
listen to check whether the compressor is running. Use manual
pump to free hose of condensation
5
If pump is pumping
➞
stop inflow
6
Open the flap of the control unit redundant flap again manually, then
7 Open the flap of the Comfort Plus control unit again
If a fault message appears, proceed according to the control unit instructions.
Maintenance: by a maintenance expert in accordance with the maintenance interval:
8 Steps 1-7 must be carried out as described above.
9
Open the inspection chamber and check the cover seal for damage
10
Carry out a visual inspection of the upper section and visual inspection of the inspection
chamber and the control cable
11
Disconnect the system from the mains and secure it against being switched on again