15
Parameter List
–
General & Note (contd.)
P08
LFO to CV Controller
(default: 1)
0 to 119
CCs 0 to 119
[Aft]
Aftertouch
[VEL]
Velocity
[Pbd]
Pitch Bend
[off]
Off
Sets which MIDI message will control LFO modulation depth on the CV output.
P09
LFO to CV Minimum Value
(default: 0)
Range: 0 to 127
Sets the level for LFO to CV modulation when the controller is at its minimum value, allowing for a base
level of modulation to be applied at all times.
P10
LFO to CV Maximum Value
(default: 50)
Range: 0 to 127
Sets the level for LFO to CV modulation when the controller is at its maximum value.
Tip: Swap the minimum and maximum values so that the controller works backwards.
P11
LFO to CV Reset Value
(default: 0)
Range: 0 to 127
Sets the amount of LFO to CV modulation that the PRO SOLO Mk3 will reset to at power-on, upon
receiving a MIDI Controller Reset message or a new setup being loaded from memory. Use this if you
want a pre-set amount of modulation that can later be turned off using the chosen controller.
P12
Coarse Tune / Transpose
(default: 0)
Range: -24 to +24 semitones
Sets the tuning for the CV output in semitone steps. Some synthesizers may be out of adjustment or
use a non-standard base tuning, such as the original Minimoog (0V results in an F).
P13
Fine Tune
(default: 0)
Range: -127 to +127 (approximately a semitone either way)
Sets the fine-tuning for the CV output. All notes are offset by the same amount.
P14
Scale
(default: 0)
Range: -127 to +127
Sets the octave scaling (aka scale width) for the CV output. Use this if your synthesizer is not tracking
correctly. Bottom C (note #36) will not move, so tune the C two octaves above that by using this
parameter.
