Steps of disassembly and assembly of front shock are as
follows:
1.Disassemble the front disc brake.
2.Disassemble the front wheel.
3.Loosen the fixing bolt on the clamp.
4.Remove the front shock.
5.Assembly shall be carried out in the reverse order of
disassembly.
Disassembly and assembly of clamp
Steps of disassembly and assembly of clamp are as follows:
1.Disassemble the front shock.
2.Disassemble upper clamp.
3.Disassemble the adjusting nut of the steering column.
4.Remove the lower clamp.
5.Disassemble the steering column
6.Assembly shall be carried out in the reverse order of
disassembly.
Check the head steering
Steps of head steering checking are as follows:
1.Suspend the motorcycle
2.Steer the motorcycle head through the handlebars. If the motorcycle head steer smoothly and there is
no obstruction, the motorcycle head steers normally
3.If it is found that there is a sense of delay and obstruction in head steering, remove the clamp to check whether
the steering bearing is normal.
Lubrication and installation of steering head bearing
Roller
The steering bearing of the front should be coated with a layer
of lithium grease on the surface of the roller when it is
installed. Refer to the picture on the left for specific
installation.
Summary of Contents for TD125
