KAYO MOTOR TD125, Service Manual

Page: 53 / 93

Note: do not let the brake fluid splash on the paint surface, easy
to cause corrosion.
Danger: please pay attention to check whether the brake fluid
leakage, brake fluid tube is damaged. If there is leakage
problem, please contact KAYO dealer.
Refill rear disc brake fluid
The steps to refill brake fluid are as follows:
1.Remove lid screw.
2.Remove the lid
3.Add brake fluid to appropriate position
4.Install back the lid
DOT4 brake fluid is recommended.
Check the rear brake friction plate
Friction plate Check the thickness of the rear brake caliper brake disc, which
should not be less than 1 mm. If the thickness of the brake disc
is less than the minimum thickness, the whole set of brake discs
should be replaced immediately.
Danger: If it is found that the brake system is worn too much,
the corresponding parts should be replaced immediately to
avoid safety accidents. The specific replacement should be
carried out after consulting the dealer of KAYO.
Tire inspection and maintenance
Removal and installation of front wheel
The front wheel is removed in the following order:
Put the whole motorcycle on the stool and let it suspended
Remove the front disc brake cover (skip this step if there is
no cover)
Loosen the front axle lock
Hold the front wheel in place with one hand and slowly
pull out the front axle with the other
Remove the front wheel and place it in place
Assembly shall be carried out in the reverse order of
disassembly.
Removal and installation of rear wheel
The rear wheel is removed in the following order:
Remove the chain
Loosen the rear axle lock
Hold the rear wheel in place with one hand and slowly pull
out the front axle with the other
Remove the rear wheel and place it in place
Assembly shall be carried out in the reverse order of
disassembly.