KAYO MOTOR TD125, Service Manual

Page: 54 / 93

Check the outside surface of the tire
The steps for checking the tire surface are as follows:
1.Check the outside surface of the tire for scratches, holes
2.Check the tire tread height, if it is less than or equal to the
minimum height, should immediately replace the tire.
Minimum tread height
：
h=3mm.
Check tire pressure
Use the pressure gauge to check whether the tire pressure level
is in line with the standard. If the problem of low pressure often
occurs, check whether the tire is leaking. If a tire is found to be
flat, please contact the KAYO dealer.
Recommended pressure
：
Air pressure of
front wheel
Air pressure of
rear wheel
TD125 250kPa 250kPa
Note: The tire pressure should be checked under cooling
condition.
Check the wheel spokes
Spokes
Pull the adjacent spokes with your fingers to check whether the
spokes lack tension. If any spokes are loose and weak, you
must check all spokes of both wheels. If there are any
problems, please contact the KAYO dealer.
Engine installation
The steps of engine installation are as follows:
⑴ Hang the engine on the frame (take care to protect the exterior of the engine).
⑵ Install the carburetor on the manifold and tighten with nuts and bolts.
⑶
Install the throttle cable and air filter. The interface should be sealed. Install the clutch control cable.
⑷
Install the transmission chain.
⑸
Install the left rear cover or sprocket cover, tighten it with bolts, pay attention to magneto outlet.