Contents
3.1 Firmware update.......................................................................................................................................... 6
3.2 Drive the device to packing position.......................................................................................................7
3.3 Isolate the device from mains.................................................................................................................. 7
3.4 Remove device covers................................................................................................................................9
3.4.1 Removing the lower shelf tray.................................................................................................9
3.4.2 Removing the patient handle................................................................................................. 10
3.4.3 Removing the mirror.................................................................................................................10
3.4.4 Removing the carriage side covers........................................................................................11
3.4.5 Removing the upper shelf covers.......................................................................................... 11
3.4.6 Removing the tubehead front cover.................................................................................... 12
3.4.7 Removing the tubehead back cover......................................................................................13
3.4.8 Removing the rotating unit side covers...............................................................................13
3.4.9 Removing the sensor covers.................................................................................................. 14
3.5 Remove 3D sensor..................................................................................................................................... 16
3.6 Remove sensor holder assembly........................................................................................................... 18
3.7 Linear movement mechanism replacement........................................................................................19
3.8 Rotating movement motor replacement............................................................................................26
3.9 Prepare the device for disassembly...................................................................................................... 27
3.10 Disassemble the device..........................................................................................................................29
3.11 Re-assemble the device.......................................................................................................................... 31
3.12 Install the CEPH arm................................................................................................................................31
3.13 Install the new sensor holder assembly.............................................................................................31
3.14 Install CEPH secondary collimator......................................................................................................35
3.15 Finalize the installation.......................................................................................................................... 39
ORTHOPANTOMOGRAPH
™
OP 3D
3
Summary of Contents for ORTHOPANTOMOGRAPH OP 3D
Page 2: ......
