-
6
Turn out the screw and remove the bat-
tery cover.
Clamp off the minus pole of the battery.
Disconnect pole terminal to positive
pole (+).
Remove the battery.
Dispose of the used battery according
to the local provisions.
Figure 3, see cover page
Loosen both the star grips.
Pull the pushing handle backward and
tilt it to the desired position.
Press the pushing handle forward and
lock it in.
Tighten the star handles.
Figure 4, see cover page
1 OFF - Appliance is switched off.
2 Sweep.
3 Sweep suction (only Adv. model).
CAUTION
Do not sweep up packing strips, wire or
similar objects as this may damage the
sweeping mechanism.
The drive belts of the side brushes can slip
down. Tilt up the side brushes only when
the appliance is switched off.
NOTICE
To achieve an optimum cleaning result, the
driving speed should be adjusted to take
specific situations into account.
NOTICE
During operation, the waste container
should be emptied at regular intervals.
NOTICE
Also lower side brush when cleaning along
edges.
Tilt the side brushed upward or down-
ward depending on the task.
Note
The dust blown up by the side brushes is
not sucked in. Place the side brushes at the
edge only while sweeping.
Set the programme switch to sweep or
sweep suction.
Move the appliance over the surface to
be swept.
Figure 5, see cover page
Lift, adjust and lower the lever for the
contact pressure of the sweeping roller.
+ Increase contact pressure.
– Reduce contact pressure.
Adjust the pressure by turning the turn-
ing handle for the contact pressure of
the side brushes.
+ Increase contact pressure.
– Reduce contact pressure.
Note
A very high contact pressure means in-
creased power consumption and hence
lesser usage time.
Figure 6, see cover page
Slightly press the pushing handle
downward so that the appliance lifts up
slightly towards the front.
Move the appliance with the raised up-
per part over the dirt.
Now lower the appliance again.
The battery display shows the charging sta-
tus of the battery during operations:
몇
Warning
Risk of injury on account of rotating roller
brush.
Before removing the waste container
please turn the programme selection to
"OFF" and wait until the roller brush comes
to a halt.
Note
Dust progress. As far as possible, shake off
the filter and empty the waste container in
open places.
Turn the program selection switch to
"OFF".
Pull the handle of the filter shake-off
many times and release it.
Tilt the dust suction upward.
Pull the waste container upward at the
handle and remove it from the appli-
ance.
Figure 7, see cover page
Dispose off the waste according to local
regulations.
If the sweeper is going to be out of service
for a longer time period, observe the follow-
ing points:
Park the sweeper on an even surface.
Lock the sweeper to ensure that it does
not roll off.
Clean the inside and outside of the
sweeper.
Park the machine in a safe and dry
place.
Disconnect battery.
Charge battery and recharge it approx.
every 2 months.
CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
Turn the program selection switch to
"OFF".
Lift the appliance at the carrying han-
dles when you want to transport it.
Secure the wheels of the machine with
wheel chocks.
Secure the machine with tensioning
straps or cables.
When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
CAUTION
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.
Danger
Risk of injury. Before performing any tasks
at the machine, first turn the programme
selection switch to "OFF“and clamp the ca-
ble at the minus pole of the battery.
Do not clean the appliance with a water
hose or high-pressure water jet (danger of
short circuits or other damage).
NOTICE
Do not use aggressive and abrasive deter-
gents.
몇
WARNING
Risk of injury! Wear dust mask and protec-
tive goggles.
Blow through machine with com-
pressed air.
Clean the machine with a damp cloth
which has been soaked in mild deter-
gent.
Clean the machine with a damp cloth
which has been soaked in mild deter-
gent.
Daily maintenance:
Check the sweeping roller and the side
brush for wear and wrapped belts.
Check function of all operator control el-
ements.
Weekly maintenance:
Clean both the foam filters under flow-
ing water.
Start up
Adjust the pushing handle
Operation
Programme selection
Sweeping mode
Dry floor
Sweep suction
Wet floor
Sweep
Adjust the brush contact pressure
Collect dirt
Battery display
full
glows green
30% capacity re-
maining
glows yel-
low
10% capacity re-
maining
blinks red
Protection against
total discharge; the
appliance is
switched off
glows red
Emptying waste container
Shutdown
Transport
Storage
Care and maintenance
Cleaning the inside of the machine
External cleaning of the appliance
Maintenance intervals
8
EN
