-
8
Danger
Risk of injury. Before performing any tasks
at the machine, first turn the programme
selection switch to "OFF“and clamp the ca-
ble at the minus pole of the battery.
* depending on battery type
Faults
Fault
Remedy
Appliance cannot be started
Check fuse; replace it, if required *
Check battery; charge it, if needed
Machine is not sweeping properly
Check roller brush and side brushes for wear, replace if necessary.
Check the pad for wear, replace if required.
Dust gathers in the machine
Empty waste container
Check dust filter - clean or replace it (only Adv. model)
Check the pad for wear, replace if required.
Poor cleaning performance at edges
Replace side brush
Check the pad for wear, replace if required.
Inadequate sweep performance (only Adv. model). Check filter case seal
Check washers of the dust suction
Roller brush does not turn.
Remove belts or cords from roller brush.
Technical specifications
KM 70/30 C Bp Pack Adv.
Length x width x height
mm
1200x770x925
Roller brush diameter
mm
240
Side brush diameter
mm
320
Surface area, max.
m
2
/h
2800
Working width without/ with side brushes
mm
470/710
Volume of waste container
l
30 (40)
Power consumption of brush drive
W
150
Power consumption of dust suction
W
45
Battery (only Pack model)
Voltage
V
12
Capacity
Ah
22, 26 *
Charging time for fully discharged battery
h
12
Operating time after frequent charging
h
ca. 2,5
Type of protection
IP
X3
Charger (only Pack model)
Mains voltage
V~
120
Dust suction
Filter surface area, fine dust filter
m
2
0,6
Category of use – filter for non-hazardous dust
--
U
Nominal vacuum, suction system
kPa
0,7
Nominal volume flow, suction system
l/s
43
Working conditions
Temperature
°C
0 bis +45
Air humidity, non-condensing
%
40 - 90
Permissible overall weight
kg
58
Transport weight
kg
48
Values determined as per EN 60335-2-72
Vibration total value on arms
m/s
2
1,2
Sound pressure level L
pA
dB(A)
59
Uncertainty K
pA
dB(A)
2
Sound power level L
WA
+ Uncertainty K
WA
dB(A)
75
10
EN
