K&M FSD4000, Operating Manual

Page: 12 / 48

12 13
EN
Juice Dispenser FSD4000 © K. & M. Holland GmbH © K. & M. Holland GmbH Juice Dispenser FSD4000
EN
Subject to technical change without prior notice! Version 2.0, 11/2017 Subject to technical change without prior notice! Version 2.0, 11/2017
any damage to the juice dispenser, these data must be compatible. If in doubt, please call the
Customer Service Department.
Extension cables or portable power strips must not be used to connect the juice dispenser to
the mains power supply. These type of connections cannot guarantee the necessary safety (e.g.,
risk of overheating).
The electrical safety of the juice dispenser can only be guaranteed if the equipment is connec-
ted properly to a pre-installed earth conductor system. Compliance with this basic safety prere-
quisite is mandatory. If necessary, contact a certified electrician to proceed with the installation.
The manufacturer cannot be held liable for damage caused by a missing or broken earth con-
ductor system (e.g., risk of electric shock).
Only technicians authorised by the manufacturer shall be permitted to proceed with installation
and maintenance tasks. An improper installation, non-conforming maintenance or repairs tasks
may place the user at considerable risk. In this case, the manufacturer not be held responsible.
Only a customer service firm, a refrigeration company authorised by the manufacturer shall be
permitted to proceed with repairs on the juice dispenser. Non-compliance will make all warran-
ty claims null and void.
During the installation, maintenance tasks and repair work, the juice dispenser must be discon-
nected from the power supply. The juice dispenser is considered to be disconnected from the
mains power supply only if the following conditions are met:
n
the mains power cable of the juice dispenser is disconnected. When disconnecting the juice
dispenser from the mains power supply do not pull the cable, pull on the plug
n
the respective fuse has been removed
Only use original spare parts when replacing faulty components (see page 44 ”Wear and spare
parts list”). The manufacturer can ensure compliance with the safety requirements only if origi-
nal parts are used.