36
37
EN
Juice Dispenser FSD4000
© K. & M. Holland GmbH
© K. & M. Holland GmbH
Juice Dispenser FSD4000
EN
Subject to technical change without prior notice! Version 2.0, 11/2017
Subject to technical change without prior notice! Version 2.0, 11/2017
Bag room < „Bag room
Min. Alarm“
E 31
Fan can not be controlled,
ambient temperature too low
Normal operation, error can be
canceled
Bag room > „Bag room
Max. Alarm“
E 32
Fan can not be controlled,
ambient temperature too
high, filter dirty
Normal operation, error can be
canceled
Valve error juice line 1
„Juice“
E 41
Cable break or short circuit
at juice line valve 1
Normal operation, error can
be canceled, juice line is swit-
ched off
Valve error juice line 1
„Water“
E 41
Cable break or short circuit
at water valve 1
Normal operation, error can
be canceled, juice line is swit-
ched off
Valve error juice line 2..4
E 42..44 Cable break or short circuit
at juice line valve 2..4
Normal operation, error can
be canceled, juice line is swit-
ched off
Valve error water line
E 45
Cable break or short circuit
at water valve 5
Normal operation, error can
be canceled, juice line is swit-
ched off
Valve error inlet valve
E 46
Cable break or short circuit
at water inlet valve
Standby
8.2 Cancelling the errors in the Service-Menu
Press the grey Service-Button („Ser“) and confirm the selection by pressing the green Standby-
Button. To cancel the saved alarms please press and hold the grey Service-Button, all errors will
be cancelled. The respective error flashes during the cancelling for 3 seconds.
8.3 EEP error
The EEP error indicates that the data saved in the power-failure-proof memory are no longer
consistent.
Causes for this could be
n
Software update has been performed
n
Power failure during a write access to the power-failure-proof memory
n
Hardware error
The initialisation of the power-failure-proof memory is done by simultaneously holding down
the „Standby“ and „Service“ buttons while the mains supply of the device is switched on. First,
„EEP“ is displayed. When „EEP“ goes out and the unit starts normally, the buttons can be re-
leased. The parameters are initialised with default values, so the parameters have to be adap-
ted to the real device.
